[36/36] app/testpmd: fix primary process not polling all queues

  Here's how the problem arises.
step1: Start the app.
    dpdk-testpmd -a 0000:35:00.0 -l 0-3 -- -i --rxq=10 --txq=10

step2: Perform the following steps and send traffic. As expected,
queue 7 does not send or receive packets, and other queues do.
    port 0 rxq 7 stop
    port 0 txq 7 stop
    set fwd mac
    start

step3: Perform the following steps and send traffic. All queues
are expected to send and receive packets normally, but that's not
the case for queue 7.
    stop
    port stop all
    port start all
    start
    show port xstats all

In fact, only the value of rx_q7_packets for queue 7 is not zero,
which means queue 7 is enabled for the driver but is not involved
in packet receiving and forwarding by software. If we check queue
state by command 'show rxq info 0 7' and 'show txq info 0 7',
we see queue 7 is started as other queues are.
    Rx queue state: started
    Tx queue state: started
The queue 7 is started but cannot forward. That's the problem.

We know that each stream has a read-only "disabled" field that
control if this stream should be used to forward. This field
depends on testpmd local queue state, please see
commit 3c4426db54fc ("app/testpmd: do not poll stopped queues").
DPDK framework maintains ethdev queue state that drivers reported,
which indicates the real state of queues.

There are commands that update these two kind queue state such as
'port X rxq|txq start|stop'. But these operations take effect only
in one stop-start round. In the following stop-start round, the
preceding operations do not take effect anymore. However, only
the ethdev queue state is updated, causing the testpmd and ethdev
state information to diverge and causing unexpected side effects
as above problem.

There was a similar problem for the secondary process, please see
commit 5028f207a4fa ("app/testpmd: fix secondary process packet
forwarding").

This patch applies its workaround with some difference to the
primary process. Not all PMDs implement rte_eth_rx_queue_info_get and
rte_eth_tx_queue_info_get, however they may support deferred_start
with primary process. To not break their behavior, retain the original
testpmd local queue state for those PMDs.

Fixes: 3c4426db54fc ("app/testpmd: do not poll stopped queues")
Cc: stable@dpdk.org

Signed-off-by: Jie Hai <haijie1@huawei.com>
Acked-by: Ferruh Yigit <ferruh.yigit@amd.com>
---
 app/test-pmd/testpmd.c | 25 ++++++++++++++++++++-----
 1 file changed, 20 insertions(+), 5 deletions(-)