[v2,1/3] net/ixgbevf: fix Rx and Tx queue status get
Checks
Commit Message
Ixgbevf driver don't enable queue start/stop functions, queue status is not
updated when the HW queue enabled or disabled. It caused application can't
get correct queue status.
This patch fixes the issue by updating the queue states when the queue is
disabled or enabled.
Fixes: 429c6d86b371 ("ixgbe: prepare for vector pmd")
Fixes: f0c50e5f56fa ("ixgbe: move PMD specific fields out of base driver")
Cc: stable@dpdk.org
Signed-off-by: Qiming Yang <qiming.yang@intel.com>
Signed-off-by: Jie Hai <haijie1@huawei.com>
---
drivers/net/ixgbe/ixgbe_rxtx.c | 6 ++++++
1 file changed, 6 insertions(+)
@@ -3378,6 +3378,7 @@ ixgbe_dev_clear_queues(struct rte_eth_dev *dev)
if (txq != NULL) {
txq->ops->release_mbufs(txq);
txq->ops->reset(txq);
+ dev->data->tx_queue_state[i] = RTE_ETH_QUEUE_STATE_STOPPED;
}
}
@@ -3387,6 +3388,7 @@ ixgbe_dev_clear_queues(struct rte_eth_dev *dev)
if (rxq != NULL) {
ixgbe_rx_queue_release_mbufs(rxq);
ixgbe_reset_rx_queue(adapter, rxq);
+ dev->data->rx_queue_state[i] = RTE_ETH_QUEUE_STATE_STOPPED;
}
}
/* If loopback mode was enabled, reconfigure the link accordingly */
@@ -5896,6 +5898,8 @@ ixgbevf_dev_rxtx_start(struct rte_eth_dev *dev)
} while (--poll_ms && !(txdctl & IXGBE_TXDCTL_ENABLE));
if (!poll_ms)
PMD_INIT_LOG(ERR, "Could not enable Tx Queue %d", i);
+ else
+ dev->data->tx_queue_state[i] = RTE_ETH_QUEUE_STATE_STARTED;
}
for (i = 0; i < dev->data->nb_rx_queues; i++) {
@@ -5913,6 +5917,8 @@ ixgbevf_dev_rxtx_start(struct rte_eth_dev *dev)
} while (--poll_ms && !(rxdctl & IXGBE_RXDCTL_ENABLE));
if (!poll_ms)
PMD_INIT_LOG(ERR, "Could not enable Rx Queue %d", i);
+ else
+ dev->data->rx_queue_state[i] = RTE_ETH_QUEUE_STATE_STARTED;
rte_wmb();
IXGBE_WRITE_REG(hw, IXGBE_VFRDT(i), rxq->nb_rx_desc - 1);