[v2,1/2] app/testpmd: update forward engine beginning
Checks
Commit Message
For each forward engine, there may be some special conditions
must be meet before the forwarding run.
Adding checks for these conditions in configuring is not suitable,
because one condition may rely on multiple configurations, and the
conditions required by each forward engine is not general.
The best solution is each forward engine has a callback to check
whether these conditions are meet, and the testpmd then call the
callback to determine whether the forwarding can be started.
There was a void callback 'port_fwd_begin' in forward engine,
it did some initialization for forwarding, this patch updates it's
return type, then we can add some checks in it to confirm whether
the forwarding can be started. In addition, this patch puts the
calling part of the callback up to before some forwarding related
status being set.
Signed-off-by: Alvin Zhang <alvinx.zhang@intel.com>
---
app/test-pmd/ieee1588fwd.c | 3 ++-
app/test-pmd/noisy_vnf.c | 4 +++-
app/test-pmd/testpmd.c | 38 ++++++++++++++++++++++++++------------
app/test-pmd/testpmd.h | 2 +-
app/test-pmd/txonly.c | 3 ++-
5 files changed, 34 insertions(+), 16 deletions(-)
@@ -198,10 +198,11 @@ struct ptpv2_msg {
port_ieee1588_tx_timestamp_check(fs->rx_port);
}
-static void
+static int
port_ieee1588_fwd_begin(portid_t pi)
{
rte_eth_timesync_enable(pi);
+ return 0;
}
static void
@@ -231,7 +231,7 @@ struct noisy_config {
rte_free(noisy_cfg[pi]);
}
-static void
+static int
noisy_fwd_begin(portid_t pi)
{
struct noisy_config *n;
@@ -273,6 +273,8 @@ struct noisy_config {
rte_exit(EXIT_FAILURE,
"--noisy-lkup-memory-size must be > 0\n");
}
+
+ return 0;
}
struct fwd_engine noisy_vnf_engine = {
@@ -2172,16 +2172,10 @@ struct extmem_param {
static void
launch_packet_forwarding(lcore_function_t *pkt_fwd_on_lcore)
{
- port_fwd_begin_t port_fwd_begin;
unsigned int i;
unsigned int lc_id;
int diag;
- port_fwd_begin = cur_fwd_config.fwd_eng->port_fwd_begin;
- if (port_fwd_begin != NULL) {
- for (i = 0; i < cur_fwd_config.nb_fwd_ports; i++)
- (*port_fwd_begin)(fwd_ports_ids[i]);
- }
for (i = 0; i < cur_fwd_config.nb_fwd_lcores; i++) {
lc_id = fwd_lcores_cpuids[i];
if ((interactive == 0) || (lc_id != rte_lcore_id())) {
@@ -2227,10 +2221,35 @@ struct extmem_param {
fprintf(stderr, "Packet forwarding already started\n");
return;
}
- test_done = 0;
fwd_config_setup();
+ port_fwd_begin = cur_fwd_config.fwd_eng->port_fwd_begin;
+ if (port_fwd_begin != NULL) {
+ for (i = 0; i < cur_fwd_config.nb_fwd_ports; i++) {
+ if (port_fwd_begin(fwd_ports_ids[i])) {
+ fprintf(stderr,
+ "Packet forwarding not ready\n");
+ return;
+ }
+ }
+ }
+
+ if (with_tx_first) {
+ port_fwd_begin = tx_only_engine.port_fwd_begin;
+ if (port_fwd_begin != NULL) {
+ for (i = 0; i < cur_fwd_config.nb_fwd_ports; i++) {
+ if (port_fwd_begin(fwd_ports_ids[i])) {
+ fprintf(stderr,
+ "Packet forwarding not ready\n");
+ return;
+ }
+ }
+ }
+ }
+
+ test_done = 0;
+
if(!no_flush_rx)
flush_fwd_rx_queues();
@@ -2239,11 +2258,6 @@ struct extmem_param {
fwd_stats_reset();
if (with_tx_first) {
- port_fwd_begin = tx_only_engine.port_fwd_begin;
- if (port_fwd_begin != NULL) {
- for (i = 0; i < cur_fwd_config.nb_fwd_ports; i++)
- (*port_fwd_begin)(fwd_ports_ids[i]);
- }
while (with_tx_first--) {
launch_packet_forwarding(
run_one_txonly_burst_on_core);
@@ -268,7 +268,7 @@ struct fwd_lcore {
* Forwards packets unchanged on the same port.
* Check that sent IEEE1588 PTP packets are timestamped by the hardware.
*/
-typedef void (*port_fwd_begin_t)(portid_t pi);
+typedef int (*port_fwd_begin_t)(portid_t pi);
typedef void (*port_fwd_end_t)(portid_t pi);
typedef void (*packet_fwd_t)(struct fwd_stream *fs);
@@ -435,7 +435,7 @@
get_end_cycles(fs, start_tsc);
}
-static void
+static int
tx_only_begin(portid_t pi)
{
uint16_t pkt_data_len;
@@ -467,6 +467,7 @@
timestamp_init_req++;
/* Make sure all settings are visible on forwarding cores.*/
rte_wmb();
+ return 0;
}
struct fwd_engine tx_only_engine = {