From: Yuri Chipchev <yuric@marvell.com>
Flow control autoneg disable is not supported
Signed-off-by: Yuri Chipchev <yuric@marvell.com>
Reviewed-by: Liron Himi <lironh@marvell.com>
---
drivers/net/mvpp2/mrvl_ethdev.c | 9 +++++++--
1 file changed, 7 insertions(+), 2 deletions(-)
@@ -2145,6 +2145,7 @@ mrvl_flow_ctrl_get(struct rte_eth_dev *dev, struct rte_eth_fc_conf *fc_conf)
if (!priv)
return -EPERM;
+ fc_conf->autoneg = 1;
ret = pp2_ppio_get_rx_pause(priv->ppio, &en);
if (ret) {
MRVL_LOG(ERR, "Failed to read rx pause state");
@@ -2194,13 +2195,17 @@ mrvl_flow_ctrl_set(struct rte_eth_dev *dev, struct rte_eth_fc_conf *fc_conf)
if (fc_conf->high_water ||
fc_conf->low_water ||
fc_conf->pause_time ||
- fc_conf->mac_ctrl_frame_fwd ||
- fc_conf->autoneg) {
+ fc_conf->mac_ctrl_frame_fwd) {
MRVL_LOG(ERR, "Flowctrl parameter is not supported");
return -EINVAL;
}
+ if (fc_conf->autoneg == 0) {
+ MRVL_LOG(ERR, "Flowctrl Autoneg disable is not supported");
+ return -EINVAL;
+ }
+
switch (fc_conf->mode) {
case RTE_FC_FULL:
rx_en = 1;