[v2,7/9] net/bnxt: use correct default Rx queue for thor
Checks
Commit Message
From: Lance Richardson <lance.richardson@broadcom.com>
Use first receive queue assigned to VNIC as the default receive queue
when configuring Thor VNICs. This is necessary e.g. in order for flow
redirection to a specific receive queue to work correctly.
Fixes: f8168ca0e690 ("net/bnxt: support thor controller")
Signed-off-by: Lance Richardson <lance.richardson@broadcom.com>
Reviewed-by: Ajit Kumar Khaparde <ajit.khaparde@broadcom.com>
---
drivers/net/bnxt/bnxt_hwrm.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
@@ -1692,7 +1692,8 @@ int bnxt_hwrm_vnic_cfg(struct bnxt *bp, struct bnxt_vnic_info *vnic)
HWRM_PREP(req, VNIC_CFG, BNXT_USE_CHIMP_MB);
if (BNXT_CHIP_THOR(bp)) {
- struct bnxt_rx_queue *rxq = bp->eth_dev->data->rx_queues[0];
+ struct bnxt_rx_queue *rxq =
+ bp->eth_dev->data->rx_queues[vnic->start_grp_id];
struct bnxt_rx_ring_info *rxr = rxq->rx_ring;
struct bnxt_cp_ring_info *cpr = rxq->cp_ring;