[v3,2/2] ethdev: prohibit polling of a stopped queue
Checks
Commit Message
Whether it is allowed to call Rx/Tx functions for a stopped queue
was undocumented. Some PMDs make this behavior a no-op
either by explicitly checking the queue state
or by the way how their routines are implemented or HW works.
No-op behavior may be convenient for application developers.
But it also means that pollers of stopped queues
would go all the way down to PMD Rx/Tx routines, wasting cycles.
Some PMDs would do a check for the queue state on data path,
even though it may never be needed for a particular application.
Also, use cases for stopping queues or starting them deferred
do not logically require polling stopped queues.
Use case 1: a secondary that was polling the queue has crashed,
the primary is doing a recovery to free all mbufs.
By definition the queue to be restarted is not polled.
Use case 2: deferred queue start or queue reconfiguration.
The polling thread must be synchronized anyway,
because queue start and stop are non-atomic.
Prohibit calling Rx/Tx functions on stopped queues.
Fixes: 0748be2cf9a2 ("ethdev: queue start and stop")
Cc: stable@dpdk.org
Signed-off-by: Dmitry Kozlyuk <dkozlyuk@nvidia.com>
Acked-by: Matan Azrad <matan@nvidia.com>
---
lib/ethdev/rte_ethdev.h | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
@@ -74,7 +74,7 @@
* rte_eth_rx_queue_setup()), it must call rte_eth_dev_stop() first to stop the
* device and then do the reconfiguration before calling rte_eth_dev_start()
* again. The transmit and receive functions should not be invoked when the
- * device is stopped.
+ * device is stopped or when the queue is stopped (for that queue).
*
* Please note that some configuration is not stored between calls to
* rte_eth_dev_stop()/rte_eth_dev_start(). The following configuration will