From: Liron Himi <lironh@marvell.com>
In case ppio was not initialized yet (only at 'start' function)
the flow-ctrl setting should be saved for later stage.
Signed-off-by: Liron Himi <lironh@marvell.com>
---
drivers/net/mvpp2/mrvl_ethdev.c | 26 +++++++++++++++++++++-----
drivers/net/mvpp2/mrvl_ethdev.h | 2 ++
2 files changed, 23 insertions(+), 5 deletions(-)
@@ -164,6 +164,8 @@ static int
mrvl_vlan_filter_set(struct rte_eth_dev *dev, uint16_t vlan_id, int on);
static int mrvl_promiscuous_enable(struct rte_eth_dev *dev);
static int mrvl_allmulticast_enable(struct rte_eth_dev *dev);
+static int
+mrvl_flow_ctrl_set(struct rte_eth_dev *dev, struct rte_eth_fc_conf *fc_conf);
#define MRVL_XSTATS_TBL_ENTRY(name) { \
#name, offsetof(struct pp2_ppio_statistics, name), \
@@ -915,6 +917,15 @@ mrvl_dev_start(struct rte_eth_dev *dev)
if (dev->data->promiscuous == 1)
mrvl_promiscuous_enable(dev);
+ if (priv->flow_ctrl) {
+ ret = mrvl_flow_ctrl_set(dev, &priv->fc_conf);
+ if (ret) {
+ MRVL_LOG(ERR, "Failed to configure flow control");
+ goto out;
+ }
+ priv->flow_ctrl = 0;
+ }
+
if (dev->data->dev_link.link_status == ETH_LINK_UP) {
ret = mrvl_dev_set_link_up(dev);
if (ret) {
@@ -2150,8 +2161,10 @@ mrvl_flow_ctrl_get(struct rte_eth_dev *dev, struct rte_eth_fc_conf *fc_conf)
struct mrvl_priv *priv = dev->data->dev_private;
int ret, en;
- if (!priv)
- return -EPERM;
+ if (!priv->ppio) {
+ memcpy(fc_conf, &priv->fc_conf, sizeof(struct rte_eth_fc_conf));
+ return 0;
+ }
fc_conf->autoneg = 1;
ret = pp2_ppio_get_rx_pause(priv->ppio, &en);
@@ -2197,9 +2210,6 @@ mrvl_flow_ctrl_set(struct rte_eth_dev *dev, struct rte_eth_fc_conf *fc_conf)
int ret;
int rx_en, tx_en;
- if (!priv)
- return -EPERM;
-
if (fc_conf->high_water ||
fc_conf->low_water ||
fc_conf->pause_time ||
@@ -2214,6 +2224,12 @@ mrvl_flow_ctrl_set(struct rte_eth_dev *dev, struct rte_eth_fc_conf *fc_conf)
return -EINVAL;
}
+ if (!priv->ppio) {
+ memcpy(&priv->fc_conf, fc_conf, sizeof(struct rte_eth_fc_conf));
+ priv->flow_ctrl = 1;
+ return 0;
+ }
+
switch (fc_conf->mode) {
case RTE_FC_FULL:
rx_en = 1;
@@ -160,6 +160,8 @@ struct mrvl_priv {
uint8_t isolated;
uint8_t multiseg;
uint16_t max_mtu;
+ uint8_t flow_ctrl;
+ struct rte_eth_fc_conf fc_conf;
struct pp2_ppio_params ppio_params;
struct pp2_cls_qos_tbl_params qos_tbl_params;