[v2,04/20] net/ixgbe/base: change flow for "Apply Update" command
Checks
Commit Message
For the "Apply Update" command the firmware does not
given an response. For this command, success should
be return.
Signed-off-by: Mateusz Kowalski <mateusz.kowalski@intel.com>
Signed-off-by: Guinan Sun <guinanx.sun@intel.com>
---
drivers/net/ixgbe/base/ixgbe_common.c | 9 ++++++++-
1 file changed, 8 insertions(+), 1 deletion(-)
@@ -4584,11 +4584,18 @@ s32 ixgbe_hic_unlocked(struct ixgbe_hw *hw, u32 *buffer, u32 length,
msec_delay(1);
}
+ /* For each command except "Apply Update" perform
+ * status checks in the HICR registry.
+ */
+ if ((buffer[0] & IXGBE_HOST_INTERFACE_MASK_CMD) ==
+ IXGBE_HOST_INTERFACE_APPLY_UPDATE_CMD)
+ return IXGBE_SUCCESS;
+
/* Check command completion */
if ((timeout && i == timeout) ||
!(IXGBE_READ_REG(hw, IXGBE_HICR) & IXGBE_HICR_SV)) {
ERROR_REPORT1(IXGBE_ERROR_CAUTION,
- "Command has failed with no status valid.\n");
+ "Command has failed with no status valid.\n");
return IXGBE_ERR_HOST_INTERFACE_COMMAND;
}