Hi,
> -----Original Message-----
> From: dev <dev-bounces@dpdk.org> On Behalf Of Raslan Darawsheh
> Sent: Monday, November 11, 2019 1:40 PM
> To: Slava Ovsiienko <viacheslavo@mellanox.com>
> Cc: Thomas Monjalon <thomas@monjalon.net>; dev@dpdk.org
> Subject: [dpdk-dev] [PATCH v2] net/mlx5: set VF MAC address from host
>
> Allow to configure the default MAC address of a VF
> via its representor port in the host.
>
> An API was proposed to specify explicitly the VF as a
> target:
> https://eur03.safelinks.protection.outlook.com/?url=https%3A%2F%2Fpatch
> es.dpdk.org%2Fpatch%2F62176%2F&data=02%7C01%7Crasland%40mell
> anox.com%7Ceae200f7fe9a4dfd9f4a08d7669bf317%7Ca652971c7d2e4d9ba6a
> 4d149256f461b%7C0%7C0%7C637090692316231424&sdata=r%2Faxjgak6
> wG8192hP8iXGmM9i67ZwcxGRcNYhgirl5Y%3D&reserved=0
>
> It has been rejected by the technical board in order to
> keep compatibility with behavior in Intel PMDs.
> https://eur03.safelinks.protection.outlook.com/?url=http%3A%2F%2Fmails.
> dpdk.org%2Farchives%2Fdev%2F2019-
> November%2F150588.html&data=02%7C01%7Crasland%40mellanox.co
> m%7Ceae200f7fe9a4dfd9f4a08d7669bf317%7Ca652971c7d2e4d9ba6a4d1492
> 56f461b%7C0%7C0%7C637090692316231424&sdata=5ST1D5mGMze5IGa
> LSm%2FjwbQuB4bs0UJ1HsaVqEoxfzo%3D&reserved=0
>
> Signed-off-by: Thomas Monjalon <thomas@monjalon.net>
> Signed-off-by: Raslan Darawsheh <rasland@mellanox.com>
> ---
> v2: use RTE_PTR_DIFF, and change the use of representor id to representor
> bit
> ---
> drivers/net/mlx5/mlx5.h | 2 +
> drivers/net/mlx5/mlx5_mac.c | 20 +++++++++
> drivers/net/mlx5/mlx5_nl.c | 98
> ++++++++++++++++++++++++++++++++++++++++++++-
> 3 files changed, 119 insertions(+), 1 deletion(-)
>
Patch applied to next-net-mlx,
Kindest regards,
Raslan Darawsheh
@@ -997,6 +997,8 @@ int mlx5_nl_promisc(struct rte_eth_dev *dev, int enable);
int mlx5_nl_allmulti(struct rte_eth_dev *dev, int enable);
unsigned int mlx5_nl_portnum(int nl, const char *name);
unsigned int mlx5_nl_ifindex(int nl, const char *name, uint32_t pindex);
+int mlx5_nl_vf_mac_addr_modify(struct rte_eth_dev *dev,
+ struct rte_ether_addr *mac, int vf_index);
int mlx5_nl_switch_info(int nl, unsigned int ifindex,
struct mlx5_switch_info *info);
@@ -197,6 +197,26 @@ mlx5_mac_addr_add(struct rte_eth_dev *dev, struct rte_ether_addr *mac,
int
mlx5_mac_addr_set(struct rte_eth_dev *dev, struct rte_ether_addr *mac_addr)
{
+ uint16_t port_id;
+ struct mlx5_priv *priv = dev->data->dev_private;
+
+ /* Configuring the VF instead of its representor. */
+ if (priv->representor) {
+ DRV_LOG(DEBUG, "VF represented by port %u setting primary MAC address",
+ dev->data->port_id);
+ RTE_ETH_FOREACH_DEV_SIBLING(port_id, dev->data->port_id) {
+ priv = rte_eth_devices[port_id].data->dev_private;
+ if (priv->master == 1) {
+ priv = dev->data->dev_private;
+ return mlx5_nl_vf_mac_addr_modify
+ (&rte_eth_devices[port_id],
+ mac_addr, priv->representor_id);
+ }
+ }
+ rte_errno = -ENOTSUP;
+ return rte_errno;
+ }
+
DRV_LOG(DEBUG, "port %u setting primary MAC address",
dev->data->port_id);
return mlx5_mac_addr_add(dev, mac_addr, 0, 0);
@@ -42,7 +42,15 @@
#define MLX5_NDA_RTA(r) \
((struct rtattr *)(((char *)(r)) + NLMSG_ALIGN(sizeof(struct ndmsg))))
#endif
-
+/*
+ * Define NLMSG_TAIL as defined in iproute2 sources.
+ *
+ * see in iproute2 sources file include/libnetlink.h
+ */
+#ifndef NLMSG_TAIL
+#define NLMSG_TAIL(nmsg) \
+ ((struct rtattr *)(((char *)(nmsg)) + NLMSG_ALIGN((nmsg)->nlmsg_len)))
+#endif
/*
* The following definitions are normally found in rdma/rdma_netlink.h,
* however they are so recent that most systems do not expose them yet.
@@ -494,6 +502,94 @@ mlx5_nl_mac_addr_modify(struct rte_eth_dev *dev, struct rte_ether_addr *mac,
}
/**
+ * Modify the VF MAC address neighbour table with Netlink.
+ *
+ * @param dev
+ * Pointer to Ethernet device.
+ * @param mac
+ * MAC address to consider.
+ * @param vf_index
+ * VF index.
+ *
+ * @return
+ * 0 on success, a negative errno value otherwise and rte_errno is set.
+ */
+int
+mlx5_nl_vf_mac_addr_modify(struct rte_eth_dev *dev,
+ struct rte_ether_addr *mac, int vf_index)
+{
+ int fd, ret;
+ struct mlx5_priv *priv = dev->data->dev_private;
+ unsigned int iface_idx = mlx5_ifindex(dev);
+ struct {
+ struct nlmsghdr hdr;
+ struct ifinfomsg ifm;
+ struct rtattr vf_list_rta;
+ struct rtattr vf_info_rta;
+ struct rtattr vf_mac_rta;
+ struct ifla_vf_mac ivm;
+ } req = {
+ .hdr = {
+ .nlmsg_len = NLMSG_LENGTH(sizeof(struct ifinfomsg)),
+ .nlmsg_flags = NLM_F_REQUEST | NLM_F_ACK,
+ .nlmsg_type = RTM_BASE,
+ },
+ .ifm = {
+ .ifi_index = iface_idx,
+ },
+ .vf_list_rta = {
+ .rta_type = IFLA_VFINFO_LIST,
+ .rta_len = RTA_ALIGN(RTA_LENGTH(0)),
+ },
+ .vf_info_rta = {
+ .rta_type = IFLA_VF_INFO,
+ .rta_len = RTA_ALIGN(RTA_LENGTH(0)),
+ },
+ .vf_mac_rta = {
+ .rta_type = IFLA_VF_MAC,
+ },
+ };
+ uint32_t sn = priv->nl_sn++;
+ struct ifla_vf_mac ivm = {
+ .vf = vf_index,
+ };
+
+ memcpy(&ivm.mac, mac, RTE_ETHER_ADDR_LEN);
+ memcpy(RTA_DATA(&req.vf_mac_rta), &ivm, sizeof(ivm));
+
+ req.vf_mac_rta.rta_len = RTA_LENGTH(sizeof(ivm));
+ req.hdr.nlmsg_len = NLMSG_ALIGN(req.hdr.nlmsg_len) +
+ RTA_ALIGN(req.vf_list_rta.rta_len) +
+ RTA_ALIGN(req.vf_info_rta.rta_len) +
+ RTA_ALIGN(req.vf_mac_rta.rta_len);
+ req.vf_list_rta.rta_len = RTE_PTR_DIFF(NLMSG_TAIL(&req.hdr),
+ &req.vf_list_rta);
+ req.vf_info_rta.rta_len = RTE_PTR_DIFF(NLMSG_TAIL(&req.hdr),
+ &req.vf_info_rta);
+
+ fd = priv->nl_socket_route;
+ if (fd < 0)
+ return -1;
+ ret = mlx5_nl_send(fd, &req.hdr, sn);
+ if (ret < 0)
+ goto error;
+ ret = mlx5_nl_recv(fd, sn, NULL, NULL);
+ if (ret < 0)
+ goto error;
+ return 0;
+error:
+ DRV_LOG(ERR,
+ "representor %u cannot set VF MAC address "
+ "%02X:%02X:%02X:%02X:%02X:%02X : %s",
+ vf_index,
+ mac->addr_bytes[0], mac->addr_bytes[1],
+ mac->addr_bytes[2], mac->addr_bytes[3],
+ mac->addr_bytes[4], mac->addr_bytes[5],
+ strerror(rte_errno));
+ return -rte_errno;
+}
+
+/**
* Add a MAC address.
*
* @param dev