diff mbox

[dpdk-dev,v2,6/6] net/vmxnet3: enable lro

Message ID 1471997140-46527-7-git-send-email-yongwang@vmware.com (mailing list archive)
State Superseded, archived
Delegated to: Bruce Richardson
Headers

Commit Message

Yong Wang Aug. 24, 2016, 12:05 a.m. UTC 
  The current implementation of jumbo frame rx can be used for
LRO directly without changes.  This change enables device
LRO if requested.

Note that since jumbo frame uses both ring0 and ring1, it
cannot be enabled in UPT (VMDirectPath) mode.

Signed-off-by: Yong Wang <yongwang@vmware.com>
---
 doc/guides/nics/features/vmxnet3.ini | 1 +
 drivers/net/vmxnet3/vmxnet3_ethdev.c | 8 +++++++-
 2 files changed, 8 insertions(+), 1 deletion(-)
diff mbox

Patch

diff --git a/doc/guides/nics/features/vmxnet3.ini b/doc/guides/nics/features/vmxnet3.ini
index c5c75ad..ef95932 100644
--- a/doc/guides/nics/features/vmxnet3.ini
+++ b/doc/guides/nics/features/vmxnet3.ini
@@ -9,6 +9,7 @@  Link status event    = Y
 Queue start/stop     = Y
 MTU update           = Y
 Jumbo frame          = Y
+LRO                  = Y
 TSO                  = Y
 Promiscuous mode     = Y
 Allmulticast mode    = Y
diff --git a/drivers/net/vmxnet3/vmxnet3_ethdev.c b/drivers/net/vmxnet3/vmxnet3_ethdev.c
index 6b1e720..0d7732d 100644
--- a/drivers/net/vmxnet3/vmxnet3_ethdev.c
+++ b/drivers/net/vmxnet3/vmxnet3_ethdev.c
@@ -540,6 +540,11 @@  vmxnet3_setup_driver_shared(struct rte_eth_dev *dev)
 	if (dev->data->dev_conf.rxmode.hw_ip_checksum)
 		devRead->misc.uptFeatures |= VMXNET3_F_RXCSUM;
 
+	if (dev->data->dev_conf.rxmode.enable_lro) {
+		devRead->misc.uptFeatures |= VMXNET3_F_LRO;
+		devRead->misc.maxNumRxSG = 0;
+	}
+
 	if (port_conf.rxmode.mq_mode == ETH_MQ_RX_RSS) {
 		ret = vmxnet3_rss_configure(dev);
 		if (ret != VMXNET3_SUCCESS)
@@ -741,7 +746,8 @@  vmxnet3_dev_info_get(__rte_unused struct rte_eth_dev *dev,
 	dev_info->rx_offload_capa =
 		DEV_RX_OFFLOAD_VLAN_STRIP |
 		DEV_RX_OFFLOAD_UDP_CKSUM |
-		DEV_RX_OFFLOAD_TCP_CKSUM;
+		DEV_RX_OFFLOAD_TCP_CKSUM |
+		DEV_RX_OFFLOAD_TCP_LRO;
 
 	dev_info->tx_offload_capa =
 		DEV_TX_OFFLOAD_VLAN_INSERT |