[v7,20/20] drivers/failsafe: replace references to slave devices
Checks
Commit Message
The term slave is only used in some comments and can be
replaced with sub devices, as done elsewhere.
Signed-off-by: Stephen Hemminger <stephen@networkplumber.org>
---
drivers/net/failsafe/failsafe.c | 6 +++---
drivers/net/failsafe/failsafe_private.h | 2 +-
2 files changed, 4 insertions(+), 4 deletions(-)
@@ -229,7 +229,7 @@ fs_eth_dev_create(struct rte_vdev_device *vdev)
if (failsafe_mac_from_arg) {
/*
* If MAC address was provided as a parameter,
- * apply to all probed slaves.
+ * apply to all probed subdevices.
*/
FOREACH_SUBDEV_STATE(sdev, i, dev, DEV_PROBED) {
ret = rte_eth_dev_default_mac_addr_set(PORT_ID(sdev),
@@ -254,8 +254,8 @@ fs_eth_dev_create(struct rte_vdev_device *vdev)
* If no device has been probed and no ether_addr
* has been provided on the command line, use a random
* valid one.
- * It will be applied during future slave state syncs to
- * probed slaves.
+ * It will be applied during future state syncs to
+ * probed subdevices.
*/
if (i == priv->subs_tail)
rte_eth_random_addr(&mac->addr_bytes[0]);
@@ -149,7 +149,7 @@ struct fs_priv {
/*
* Set of sub_devices.
* subs[0] is the preferred device
- * any other is just another slave
+ * any other is just another sub device
*/
struct sub_device *subs; /* shared between processes */
uint8_t subs_head; /* if head == tail, no subs */